NEWS
NEWS
/
/
Precautions in plastic mold design

Precautions in plastic mold design

  • 作者:
  • 来源:
  • 发布时间:2021-11-02 09:42
  • 访问量:

【概要】:The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

Precautions in plastic mold design

【概要描述】The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

  • 分类:新闻资讯
  • 作者:
  • 来源:
  • 发布时间:2021-11-02 09:42
  • 访问量:0
详情

The feed inlet shall be set at the thicker part of the product to ensure smooth and complete mold filling. It shall be set at a place that does not affect the appearance and function of the product as far as possible. The pull rod can be set at the edge or bottom and in the cold cavity near the gate to facilitate the demoulding of runner, large or flat products. It is recommended to use multi-point feeding to prevent product warpage, deformation and material shortage.

扫二维码用手机看

上一个:
上一个:

Copyright 2021. 深圳市海德模具有限公司. All rights reserved. 粤ICP备2021078526号  技术支持 www.300.cn